ON MANY SLEDS WHEN THE TANK SEEMS FULL, GENTLY PUT WEIGHT ON THE REAR BUMPER AND THE TANK WILL "BURP" ALLOWING UP TO ANOTHER GALLON OF FUEL TO BE ADDED
HYDRAULIC WHEEL SYSTEM
These are custom fit and special order, so give us a call for more details 1-855-387-8757
Video at bottom:
Do you have problems with your carbides on asphalt, concrete and plywood? In 3-5 seconds, deploy this wheel system without even getting off your snowmobile! Patented in Canada and the United States. WheelTracker is the only hydraulic system with the wheels inside the skis. Designed for 98% of snowmobiles from 2010-present. MSRP $1199.99/kit.
- Handlebar rocker switch
- Deploys in 3 seconds, retracts in 3 seconds
- Hydraulic pump under your hood
- Phone support during installation
- Only 3.5lbs per ski
We have sold hundreds of these and have custom fit designs with correct brackets to fit 98% of the snowmobiles from 2010 to present on the market. With some electrical and hydraulic knowledge and mechanical aptitude you can install these yourself. And we are just a phone call away if you have any questions.
Hydraulic retractable wheel system with automatic positioning. This system allows you to deploy your wheels while sitting on your snowmobile. The switch is located directly on the handlebars. The positioning is done in 3-5 seconds for deployment and 3-5 seconds to retract them. The total weight of this hydraulic system is 11 pounds, 3.5 pounds per ski and 5 pounds for the oil-filled pump also including the weight of the hoses and wiring. When backing up or moving forward the wheels will not deactivate. Even if there are holes or obstacles in your way, the wheels will remain in the rolling position. This is a very durable product with debris shields.
This product has been designed for all weather conditions down to -60 degrees Celsius (water, salt, calcium, ice, snow ...). This hydraulic system includes 1 12 volt pump with 1 30 amp motor producing 600 lbs of pressure and a flow rate of 2.8 liters per minute, 4 plastic coated stainless hoses and 2 billet aluminum hydraulic cylinders. Installation is usually done in 5-6 hours.
Your hydraulic components will remain the same, even if you decide to change the brand of snowmobile. You just have to change some supports and voila, it will suit your new brand of snowmobile.